How to Mix Trenbolone Acetate Powder
  • Vote Up0Vote Down venynxvenynx
    Posts: 2,389Member

    Tren Acetate powder is famous for being one of the strongest anabolic
    steroids in the world. It is especially effective in the cases of
    performance enhancement. What’s more, trenbolone acetate is also one of
    the most versatile since it works well in bulking and cutting cycles
    alike. Many people get raw trenbolone acetate powder from internet, and
    it is easy to buy trenbolone acetate powder online. But how to mix raw
    trenbolone acetate powder when buy trenbolone acetate powder online?
    Here is the recipe for reference. Before you mix raw trenbolone acetate
    powder(trenbolone acetate homebrew), you must know what is that and what
    are you doing, and the risk. Do not try trenbolone actate homebrew if
    you do not know anything about trenbolone acetate.Testolone powder
    Step 1:

    Weigh the steroid powder into the glass beaker as shown above, add the Benzyl Alcohol and Benzyl Benzoate

    Step 2:

    The solvents will begin immediately dissolving the powder but in
    order to speed the process up it is possible to use a water bath. Pace
    the vial into a few cm of water in a pan or something similar: it is
    important not to use water that is too hot because this will cause some
    products to oxidize-150f is a good temperature to use, alternatively
    boiled water from the kettle.

    The carrier oil should be the same temperature as the solution when
    it is added so if you warm the solution in a water bath you should also
    the same to the carrier oil. The objective at this point is simply to
    fully dissolved the powder into the solvents. There should be no
    “Hormone swirls” or any visible powder remaining in the solution and
    once this is achieved move on to the next step.

    Step 3:

    Add the warmed grape seed oil to the solution, this case 35ml must be
    added. Mix thoroughly again, there should be no hormone swirls-once
    this occurs remove immediately from the water bath and move on to the
    filtering process.

    The steroid powder is fully dissolved in the solvents, the carrier oil is added and the product is ready to be filtered.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Top Posters

Who's Online (0)